Fagor CNC 8065 - Page 672

·672·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to machine parameters for JOG mode.
(V.)MPMAN.MPGAXIS[hw]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Handwheel [hw]. Logic number of the axis associated with the handwheel.
If the variable returns a ·0· value, it means that it is a general handwheel that may be used
to move any axis.
Syntax.
·hw· Handwheel number.
Remarks.
The logic number of the axes is determined by the order in which the axes have been defined
in the machine parameter table. The first axis of the table will be logic axis -1- and so on.
CONFIGURE THE JOG KEYS.
(V.)MPMAN.JOGKEYDEF[jk]
(V.)MPMAN.JOGKEY2DEF[jk]
··
(V.)MPMAN.JOGKEY8DEF[jk]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Jog key [jk]. Axis and moving direction.
Syntax.
·jk· Jog key number.
V.MPMAN.MPGAXIS[1] Handwheel ·1·.
JOG-PANEL LCD-10K
V.MPMAN.JOGKEYDEF[11] Jog key ·11· of first keyboard.
V.MPMAN.JOGKEY3DEF[11] Jog key ·11· of third keyboard.
1
4
2
5
3
6
789
10 11 12
13 14 15
123
789
456
U
S
E
R
K
E
Y
S