Fagor CNC 8065 - Page 673

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·673·
Variables related to machine parameters for JOG mode.
Values of the variable.
This variable returns one of the following values.
Remarks.
The logic number of the axes is determined by the order in which the axes have been defined
in the machine parameter table. The first axis of the table will be logic axis -1- and so on.
(V.)MPMAN.JOGTYPE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Behavior of the JOG keys.
Values of the variable.
This variable returns one of the following values.
CONFIGURE THE USER KEYS AS JOG KEYS
(V.)MPMAN.USERKEYDEF[uk]
(V.)MPMAN.USERKEY2DEF[uk]
··
(V.)MPMAN.USERKEY8DEF[uk]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
User key [uk] as jog key.
Value. Meaning.
0 The key has no function assigned to it.
1 ·· 16 The key is assigned to the logic axis 1, 2, ··, 16 for movements in the positive direction.
-1 ·· -16 The key is assigned to the logic axis 1, 2, ··, 16 for movements in the negative
direction.
101 ·· 116 The key is assigned to the logic axis 1, 2, ··, 16.
300 The key is assigned to the rapid movement.
301 The key is assigned to the movement in the positive direction.
302 The key is assigned to the movement in the negative direction.
V.MPMAN.JOGTYPE
Value. Meaning.
0 Pressed axis. The axis will move while both keys are pressed, the axis key and the
direction key.
1 Selected axis. Pressing the axis key selects the axis. The axis will move while the
direction key is kept pressed.