Table of Contents
4-8 Ethernet Interface 4-25
4-8-1 TCP/IP Setup Procedure 4-26
4-8-2 TCP/IP Setup Procedure (HFC3000 User Console Software) 4-29
Chapter 5: Power Up and Operational Tests
5-1 Items to be Checked Before Power On 5-2
5-2 Items to be Checked When Powering On the Equipment 5-3
5-3 Input Initial Setting Data 5-4
Chapter 6 Fastening Operation
6-1 Changing between RUN and PROGRAM Modes 6-2
6-2 RUN Mode 6-5
6-2-1 Changing Display Modes (in the RUN Mode) 6-6
6-2-2 Real Time Display Mode 6-7
6-2-3 Fastening Result Display Mode 6-10
6-2-4 Parameter Setting Mode 6-12
6-2-5 System Parameter Display Mode 6-13
6-2-6 Status Display Mode 6-14
6-3 Parameter Program Mode 6-16
6-3-1 Changing Modes in the PROGRAM Mode 6-16
6-3-2 Parameter Selection Mode 6-17
6-3-3 Parameter Editing Mode 6-19
6-4
Parameter Copy/Erasing the Fastening Result History/Formatting of the CF Card
6-21
6-5 Fastening Reject (NG) Result Indications 6-23
6-5-1 Example of Fastening Reject item Display 6-24
6-5-2 Reject Judgment / Limits 6-26
6-5-3 Fastening Speed and Time 6-34
6-5-4 Auxiliary Attachments – Tubenut Head Setup 6-36
6-6 Parameter Structure 6-39
6-6-1 System Parameters 6-40
6-6-2 Fastening Parameters (Torque, Angle, Rate, Time, Speed, Rev/Current, other) 6-55
6-6-3 Pulse Operation 6-75
6-6-4 Gyro Operation 6-77
6-6-5 Sequence Operation 6-78
Chapter 7 Troubleshooting
7-1 Abnormal State Display 7-2
7-2 Abnormality Details/Causes and Recovery Methods 7-3
7-3 Spindle Judgment: Checking REJECT Reason 7-15
7-4 Ethernet Communication 7-16
7-5 RTC (Real Time Clock Setup) 7-18
To Next Page
Loading...