FEC Handheld Nutrunner HFC3000 - Chapter 3 System Descriptions; Controller Rear Panel

Chapter 4 Installation and Wiring
PAGE 4-2
4-1 Installation Procedure
Follow the installation procedures of the HFC3000 System in the order prescribed below.
№
Item
Contents
Page
①
Installation
Controller mounting and dimensions.
4-2
PAGE 4-2
②
Connection of input power
source
Input power connection
4-3
PAGE 4-3
③
Connection of tool cable
Connection between the controller rear panel (CN1)
and tool
4-4
PAGE 4-4
④
Connection of external control
signal
PLC Input / output signal Connection and control
signals.
4-5
PAGE 4-5
⑤
Power up
Power up after checking the wiring and checking the
power source voltage.
5-1
PAGE 5-1
⑥
Set Parameter values
Torque value, angle value, speed, timer, etc., settings
Chapter 6
PAGE 6-1
⑦
Initial operation check
Perform initial operation & checks.
5-2
PAGE 5-2