FEC Handheld Nutrunner HFC3000 - System Parameters

Chapter 6 Fastening Operation
PAGE 6-40
6-6-1 System Parameters
<System Parameters> Par No. Indication: SYS [Setting Change marked “O” user changable]
Item
D-No.
Contents
Setting
change
Unit
controller
Information 1
000
Torque Unit
○
001
Software Version
002
Amplifier Version
003
System Indication
004
Spindle Adapter Gear Ratio
○
005
For Adjustment by the Manufacturer
006
For Adjustment by the Manufacturer
007
Communication Axis Indication
008
Axis Cycle Count (×1 million)
009
Axis Cycle Count (×1)
010
controller Maximum Current
011
IP Address (upper 6 digits): 192.168
○
012
IP Address (lower 6 digits): 11.10
○
013
Subnet Mask (upper 6 digits): 255.255
○
014
Subnet Mask (lower 6 digits): 255.0
○
015
Default Gateway (upper 6 digits): 192.168
○
016
Default Gateway (lower 6 digits): 11.1
○
017
MAC Address (upper 6 digits): 001F98
018
MAC Address (lower 6 digits): 001000
019
RTC: Year/Month/Day “130725” July 25, 2013
○
020
RTC: Time “123456” 12:34 56
○
021
Erase Fastening Record/Format CF Card
○
022
Parameter Copy
○
023
For Adjustment by the Manufacturer
024
For Adjustment by the Manufacturer
025
For Adjustment by the Manufacturer
026
Controller SW1 Setting state
027
Controller SW2 Setting state
028
For Adjustment by the Manufacturer
029
For Adjustment by the Manufacturer
Options
030
Parameter Change Unlock Code
○
033
System Option 1
○
034
System Option 2
○
035
System Option 3
○
036
Gear head Type
○
037
Start Switch Level
○
038
Rapid Switch level
○
039
CW / CCW Switch Level
○
040
For Adjustment by the Manufacturer
041
//
042
//
043
//
044
//
045
//
046
//
047
//
048
//
049
//