Chapter 1 Outline
PAGE 1-6
☆ Cleaning
Do not use any organic solvents, such as thinner, to clean a Controller or a tool. The solvent could
melt the surface paint, display overlay or penetrate inside and cause damage. A cloth dampened
with alcohol or warm water should be used to lightly wipe the components.
☆ Noise
The controller is made up of electronic components and sensors – therefore, make sure there is no
equipment that will generate strong electrical noise in the surroundings.
Make sure that the cables that connect the controller and the tool are not placed inside a duct, etc.,
together with a power source line or other wiring.
☆ Handling and Shipping
It is critical that FUSION System components are properly handled and shipped in order to maintain the
System's integrity. Adhere to the following requirements for shipping and handling:
• Loose FUSION System components must be individually packaged in an approved anti-static
container or wrap to prevent damage from electrostatic discharge.
• Adhere to Chapter 2 Specifications for environmental requirements.
To Next Page
Loading...