Chapter 9 Fieldbus I/O Interfaces
PAGE 9-24
Below are the properties which must be setup for the Message Configuration of the Write_Tag.
(Right Click in MSG command)
Message Type CIP Generic
Service Type Get Attribute Single
Service Code 10
Class A2
Instance 1
Attribute 5
Destination The controller tag “VIN_Number” or whatever Write Tag you setup should be selected
Note: The FEC HFC Controller will only take a maximum of 32 Bytes for the Write_Tag (Part ID data) configurable
(between 0-32 bytes) in the HFC3000 software for the Fieldbus Message Setup. So an instance of “1” is all that is
required in the above setup for WRITING data using the Message Command.
To Next Page
Loading...