1 Safety and requirements for product use
12 Festo – P.BE-MPA-EN – 1309f – English
Certain configurations of the product have been cer tified by Underwriters Laboratories Inc. (U L) for the
USA and Canada. These configurations bear the following mark:
U L Rec ognized Component Mark for Canada and the United States
Only for connection to a NEC Class 2 supply.
Raccorder Uniquement a un circuit de Classe 2.
Note
Observe the following if the UL requirements are to be complied with in your applica-
tion:
– R ules for observing the UL certification ca n be found in the separate UL-specific
documentation. The relevant technical data listed there also apply here.
– The technical data in this documentation may show values deviating from this.
1.2.4 Instructions on this description
This description contains specific information on mounting, installing, commissioning, servicing and
converting the MPA-S valve terminal. It includes o nly the description of the pneumatic components.
Information on the electrical/electronic c omponents c an be found for:
– MPA-S with CPX terminal:
in t he description on the respect ive CPX module. An overview is provided in the sys-
tem description of your CPX terminal, in the “Descriptions of the CPX terminal” table.
– MPA-S with multi-pin plug connection, CPI interface, AS-interface:
in the respective package insert
To Next Page
Loading...
