3 Mounting and installation
Festo – P.BE-MPA-E N – 1309f – English 47
3 Mounting and installation
3.1 General instructions on mounting and dismantling 48...............................
3.2 Mounting variants 49.........................................................
3.2.1 Mounting/dismounting on H-rails 49....................................
3.2.2 Mounting/dismounting on walls 53.....................................
3.2.3 Standard fastening points of the valve terminal 54.........................
3.2.4 Additional fastening of the valve terminal 55..............................
3.3 Mounting/dismounting the inscription label holder 56..............................
3.4 Compressed air preparation 58.................................................
3.4.1 Operation with unlubricated compressed air 58...........................
3.4.2 Operation with lubricated compressed a ir 58.............................
3.5 General instructions on installation 60...........................................
3.6 Connecting the MPA-S valve terminal 62..........................................
3.6 .1 Pilot control (pilot air supply) 62........................................
3.6.2 MPA -S valve terminal with pressure zone sepa ration 63.....................
3.6.3 Operation of the MPA-S... valve terminal with reversible pressure regulators 64..
3.6.4 Setting the pressure regulator 64.......................................
3.6.5 Controller with rigid threaded c onnection (MPA1) 68.......................
3.6.6 Vacuum/ low-pressure operation 68.....................................
3.6.7 Connecting the pneumatic lines 70......................................
3.7 Installation of the tubing lines 72...............................................
3.7.1 Connecting 72......................................................
3.7.2 Removing 72.......................................................
3.7.3 Common pneumatic lines 73...........................................
3.8 Connecting the electric cables 74...............................................
3.8.1 Load voltage supply via electrical supply plate (only for M PA-S valve terminal
with CPX terminal or CPI interface) 74...................................
3.8.2 Earthing the M PA-S valve terminal 76....................................
3.9 Address assignment of the valves 78............................................
3.9.1 MPA-S valve terminal with CPX terminal 78...............................
3.9.2 MPA-S valve terminal with CPI module or AS -interface 79....................
3.9.3 MPA-S valve terminal with multi-pin plug connection 80.....................
To Next Page
Loading...
