A Technical appendix
Festo – P.BE-MPA-E N – 1309f – English 135
A.1.3 Pneumatics
Solenoid valves
Operating/pilot medium Compressed air in accordance with ISO
8573-1:2010 [7:4:4]
Notes on the operating/pilot medium Lubricated operation possible (in which case
lubricated operation will always be required)
Design – Valve sub-bases with piston spool valves
– Valve sub-bases with poppet valves
Manual override Non-detenting or turning with detent
Operating pressure/pilot pressure
–Valveswithinternal pilot air supply (branched from connection (1))
All valve sub-bases on port (1) The pressure at the connection (1) must lie within
the ra nge of the required pilot pressure of the
valves. ( diagrams Fig. A.1 … Fig. A.5, max. 8 bar)
–Valveswithexternal pilot air supply
Valve position Ident code B, E, G, J and
Matport(1)
–0.9 … 10 bar
Valve position Ident. code DS, HS, KS,
MSandNSatport(1)
–0.9 … 8 bar
Valve position Ident. code W at port (2) –0.9 … 10 bar
Valve position Ident. code X at port (4) –0.9 … 10 bar
ValvepositionIdent.codeD,H,I,Kand
Natport(1)
3…10bar
Valve position Ident. code MU, NU, KU,
andHUatport(1)
–0.9 … 10 bar
All valve sub-bases at port ( 12/14) Diagrams Fig. A.1 … Fig. A .5, pressure P2
(max. 8 bar)
Tab. A.6 Technical data: solenoid valves
To Next Page
Loading...
