A Technical appendix
130 Festo – P.BE-MPA-EN – 1309f – English
A.1 Technical data
A.1.1 General
Mechanical
Weight
Pneumatic interface or multi-pin plug connection plate
(with exhaust plate/flat plate silencer)
324 g/315 g
CPI sub-base (with exhaust plate/flat plate silencer) 427 g/418 g
A S -interface ( with exhaust plate/flat plate silencer) 396 g/360 g
Per sub-base (with seal, electronics module, electrical
interlinking module, inscription label holder, screws)
185 g
Per pneumatic air supply plate (with seal, elect rical
interlinking module, screws, ex haust plate/flat plate
silencer)
120 g/111 g
Per electrical air supply plate (with seal, e lectrical
interlinking module, screws)
200 g
Per pressure sensor plate 200 g
Per proportional pressure regulator with sub-base and
electronics module)
Approx. 575 g
Per complete CPX module Approx. 210 g
Left end plate (CPX terminal) Approx. 80 g
Right end plate (MPA-S) 55 g
Per valve (MPA1/M PA2) Approx. 56 g/approx. 100 g
Per c over plate ( M PA1/MPA2) 24 g/44 g
Per pressure regulator plate (MPA1/MPA2) 100 g/180 g
Tab. A.1 Technical data: mechanical
To Next Page
Loading...
