2Overview
30 Festo – P.BE-MPA-EN – 1309f – English
Separating seals for MPA-S valve terminals
1
2
3
4
5
6
7
8
9aJ
1 Additional identification of the seals/separating se als for the MPA-S valve terminal with ex haust
plates
2 Position of the marking for separating seals
MPA-S with flat plate silencer MPA-S with exhaust plate
3 Without marking: seal with open channels
(1), (3) and (5)
7 Separating seal, channels (3) and (5)
blocked (Ident. code R)
4 Separating seal, channels (1), (3) and (5)
blocked (Ident. code S)
8 Separating seal, channel (1) blocked (Ident.
code I)
5 Separating seal, channel (1) blocked (Ident.
code I)
9 Separating seal, channels (1), (3) and (5)
blocked (Ident. code S)
6 Separating seal, channels (3) and (5)
blocked (Ident. code R)
aJ Without marking: seal with open channels
(1), (3) and (5)
Tab. 2.9 Marking of the se al variants for sub-bases
To Next Page
Loading...
