MPA-S
Festo – P.BE-MPA-E N – 1309f – English 5
4.7 Error handling 97............................................................
4.7.1 Impairment of functions 97............................................
4.7. 2 Operating statuses of the pneumatic system 98...........................
5 Conversion and maintenance 99................................................
5.1 General instructions 100.......................................................
5.2 Dismantling the MPA-S v alve terminal 101.........................................
5.2.1 Disconnect the electrical connections 101.................................
5.2.2 Disconnecting the pneumatic connections 101.............................
5.2.3 Dismantling the MPA-S valve terminal 101.................................
5.3 Maintenance of the MPA-S valve terminal 101......................................
5.3.1 Ser vice and maintenance measures to be executed regularly 101..............
5.3.2 Cleaning the flat plate silencer 102.......................................
5.3.3 Replace the flat plate silencer or the exhaust plate 102......................
5.3.4 Replacing valves or c over plates 103.....................................
5.3.5 Replacing the proportional pressure regulator 105..........................
5.3.6 Replacing electronics modules 106......................................
5.3 .7 Replacing the sub-base, supply plate or MPA-S end plate 111.................
5.3.8 Replacing interlinking boards – MPA-S with multi-pin plug connection
or A S interface 114...................................................
5.4 Conversion of the MPA-S valve terminal 116........................................
5.4. 1 Conversion to internal or external pilot air supply 116........................
5.4.2 Conversion of the MPA-S valve terminal to diffe rent pressure zones 120.........
5.4.3 Adding valve positions 122.............................................
5.4. 4 Adding an electric supply plate (only for MPA-S valve terminal with CPX terminal
or CPI interface) 125..................................................
5.4. 5 Adding a pressure sensor plate 127......................................
5.4.6 Adding a proportional pressure regulator 127..............................
5.5 De-commissioning and disposal 128..............................................
A Technical appendix 129........................................................
A.1 Tec hnical data 130............................................................
A.1.1 General 130.........................................................
A.1.2 Operating and environmental conditions 132...............................
A.1.3 Pneumatics 135......................................................
A.1.4 Electrical data 148....................................................
A.1.5 Product key 150......................................................
A.2 Festo accessories 150.........................................................
To Next Page
Loading...
