FiberHome AN6000 Series User Manual

9 PDPs
9.2.5 PDP Power Cable
The PDP power cables are used to introduce an external -48 V power supply to the
PDP inside the cabinet. One end of the cables is connected to the power distribution
cabinet in the equipment room and the other end is connected to the PDP at the top
of the cabinet.
Structure
Table 9-2 shows the power cables for the PDP (3000063).
Table 9-2 Power Cables for the PDP (3000063)
Power Cable Type
Illustration
Mappings Between Cable Diameters
and Lengths
-48 V (16 mm
2
)
-48 V (25 mm
2
)
-48 V (35 mm
2
)
u For a power cable shorter than 20 m,
the one with a cross-sectional area of
16 mm
2
is recommended.
u For a power cable that is 20 m to 35
m long, the one with a cross-sectional
area of 25 mm
2
is recommended.
u For a power cable that is 35 m to 50
m long, the one with a cross-sectional
area of 35 mm
2
is recommended.
Note: The diameter of the PDP power
cable depends on the cable length and
the current actually carried by the PDP,
and hence should be determined
according to the project configuration.
0 V (16 mm
2
)
0 V (25 mm
2
)
0 V (35 mm
2
)
Connection
Table 9-3 Connections of the PDP (3000063) Power Cables
Cable Category
Cable Connector Connected to
Cable (blue) connecting to
the active -48 V power
supply in the equipment
room
1. Uninsulated ring
terminal
Active external power -48 V input
connector (-48V_A) of the PDP
2. Bare wire
-48 V connector of the active power
supply in the equipment room
Version: B
115

FiberHome AN6000 Series Specifications

General

Brand	FiberHome
Model	AN6000 Series
Category	Touch terminals
Language	English