EasyManua.ls Logo

Filtec FT-70c - Fill Level Functions Group

Filtec FT-70c
243 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FT-70 Fill Level Inspector Service Manual
5-12
Function Descriptions
The following section contains function descriptions for each
function group. Depending upon your FT-70 machine type,
machine configuration, and options package, some of these
options may not apply to your FT-70.
Certain functions are available only while in the Calibrate Mode or
when dip switch S1-5 is open. To determine the availability of a
function refer to the Software Functions List.
Fill Level Functions Group
X-ray Status
This function activates or deactivates the X-ray Generator. When
the X-ray Status is off Error 123 displays and the warning beacon
flashes.
The X-ray Status is automatically disabled when the Safety
Interlock Switch is turned off. To turn the X-ray Status back on you
must:
1. Turn the Safety Interlock Switch on.
2. Press Key 1 until X-RAY STATUS appears.
3. Press the Arrow Key to turn the X-ray Source Status on. The
generator will take approximately 5 seconds to reach full
power and begin generating of x-rays.
Autoshutter Status
The Electronic Autoshutter is activated when the conveyor stops
for more than one-eighth second. When the autoshutter is
activated no inspection occurs and Error 123 displays.
The Electronic Autoshutter has two settings:
Auto: The shutter closes and opens automatically in accor-
dance with the conveyor motion.
Open: Forces the shutter to remain open for a maximum of
minutes. When 5 minutes is exceeded, the setting automati-
cally reverts to Auto.
Industrial Dynamics Company, Ltd. © 40256-0600

Table of Contents

Related product manuals