FT-70 Fill Level Inspector Service Manual
5-36
Diameter Missing Lid
Prepares the FT-70 software for Diameter Missing Lid inspection
by inserting the necessary options into the software. When set to
Not Present it removes the options necessary for Diameter Missing
Lid inspection from the software.
This function does not activate or deactivate diameter missing lid
inspection, it only readies the machine. To turn diameter missing
lid inspection on or off you must use the Diameter Missing Lid
Status function.
Diameter Missing Lid Text
Allows you to create a custom name for the Diameter Missing Lid
Option. Any instance in which “Diameter Missing Lid” would
have appeared in the software, is replaced by the custom label you
created. The following options are effected:
• Dia Missing Lid Status
• Total Dia Missing Lid
• Reset Dia Missing Lid
• Dia Missing Lid Width
• Minimum Diameter Missing Lid
• Alarm Dia Missing Lid
• Dia Missing Lid Text
• Dia Missing Lid
Note
This manual assumes the default name for this option. If you
change the default text remember to substitute the new name
when reading this manual. To avoid confusion record the change
in the manual.
To create a name:
1. Press the Arrow Key until the desired character appears.
2. Press Key 6 to advance to the next space.
3. Repeat steps 1 and 2 until you complete the entry and then
press Key 5 once to enter the text.
Industrial Dynamics Company, Ltd. © 40256-0600
To Next Page
Loading...
