FT-70 Fill Level Inspector Service Manual
5-32
Underfill Text
Allows you to create a custom name for the Underfill Inspection
Option. Any instance in which “Underfill” would have appeared
in the software, is replaced by the custom label you created. The
following options are effected:
• Underfill Status
• Total Underfill
• Reset Underfill
• Alarm Underfill
• Underfill Text
Note
This manual assumes the default name for this option. If you
change the default text remember to substitute the new name
when reading this manual. To avoid confusion record the change
in the manual.
To create a name:
1. Press the Arrow Key until the desired character appears.
2. Press Key 6 to advance to the next space.
3. Repeat steps 1 and 2 until you complete the entry and then
press Key 5 once to enter the text.
Overfill Text
Allows you to create a custom name for the Overfill Inspection
Option. Any instance in which “Overfill” would have appeared in
the software, is replaced by the custom label you created. The
following options are effected:
• Overfill Status
• Total Overfill
• Reset Overfill
• Alarm Overfill
• Overfill Text
Industrial Dynamics Company, Ltd. © 40256-0600
To Next Page
Loading...
