Chapter 4: Configuring the FT-70 for Operation
4-9
3. Lower the bracket until the trigger beam contacts the container
at the widest part of the lid, or if the container is oriented
upside down so the beam contacts the container as shown in
Figure 4-4.
4. Tighten the height locking handle to secure the trigger beam
positioning.
5. If you will not be performing further alignment procedures,
turn on the Safety Interlock Switch to reactivte the X-ray
Generator. See Chapter 5: The Safety Interlock Switch.
Industrial Dynamics Company, Ltd. © Form 40256-0600
To Next Page
Loading...
