Remote control panel Panda iControl
Seite 114 - Kapitel 9: Remote control panel Panda iControl Panel_iControl_eng_modi.fm
Fischer Panda Datenblatt / Datasheet
9.3.1 Additional information
Fig. 9.3.1-1: Aditional Information screen 2l
By pressing the Enter button while the genertor is runnung the second screen appear.
On this screen following additional information regarding the Inverter will be shown:
• Temperature of the cooling plate
• Inverter output voltage
• Inverter output current
1. The revision of the hard and software is stored in the electronic memory and can be read out by the service tech-
nican.
If the iControl is in the stand by mode and the battery voltage drops under 12.1V for more than 2 min., the
iControl shut the system off to prevent the battery for total discharge.
Warning!
At the Electronic board is an voltage of 450V. Only special trai-
ned persons are allowed to open the cover of the Electronic
board. DANGER TO LIVE!
01. PMGi Inverter output voltage
02. PMGi Inverter output current
03. Generator operation hours
04. Oil pressure indication „OK“ oder „Fault“
05. PMGi Inverter temperature
06. Load indication in %
07. Generator speed
To Next Page
Loading...
