FlexDSL ORION 2 - Configuration of the Flexdsl Orion 2 Device at the Customer Premises

User Manual NTU Orion 2
109
<NETMASK 255.0.0.0>
–
set the subnet mask (this value is the same as in the
connected Ethernet network)
<GATEWAY 10.0.0.101>
– set the default gateway (this value is the same as in the
connected Ethernet network)
<INTERFACE LAN QOS 1>
– packet from the LAN port have priority 1
<INTERFACE WAN1 QOSTHRESHOLD
2>
– VLAN packets with QoS 2 or above have the highest priority
<INTERFACE INT VLAN 3>
– packets of the internal management port belong to VLAN 3
<INTERFACE INT QOS 2>
– packets from the LAN port have priority 0
<INTERFACE WAN1 ALLOW 1,2,3>
– transmit packets of VLAN 1,2,3 over the WAN1 port
Application of all configurations (Fault And Maintenance Management menu):
<APPLY ALL>
–
apply all configurations (written in the running configuration)
Confirmation of all configurations (Fault And Maintenance Management menu):
<CONFIRM>
–
confirm all configurations (written in the startup
configuration)
7.2.2 Configuration of the FlexDSL Orion 2 device at the Customer Premises
System configuration (Configuration Management menu):
<DEFAULT EVERYTHING> –
enable default settings
Line interface configuration (Configuration Management menu):
<MASTER OFF>
– enable the Slave mode
Configuration of the internal Ethernet switch (Network Management submenu):
<SETIP 10.0.2.201>
–
set the IP address of the device (depends on the
configuration of the connected network)
<NETMASK 255.0.0.0>
–
set the subnet mask (this value is the same as in the
connected Ethernet network)
<GATEWAY 10.0.0.101>
– set the default gateway (this value is the same as in the
connected Ethernet network)
<INTERFACE LAN QOS 1>
– packet from the LAN port have priority 1
<INTERFACE WAN1 QOSTHRESHOLD
2>
– VLAN packets with QoS 2 or above have the highest priority
<INTERFACE INT VLAN 3>
– packets of the internal management port belong to VLAN 3
<INTERFACE INT QOS 2>
– packets from the LAN port have priority 0
<INTERFACE WAN1 ALLOW 1,2,3>
– transmit packets of VLAN 1,2,3 over the WAN1 port
Application of all configurations (Fault And Maintenance Management menu):
<APPLY ALL>
–
apply all configurations (written in the running configuration)
Confirmation of all configurations (Fault And Maintenance Management menu):
<CONFIRM>
–
confirm all configurations (written in the startup
configuration)