FlexDSL ORION 2 - RESTORE> Command; DIFF N;R;S;B N;R;S;B > Command; DUMP N;R;S;B > Command

User Manual NTU Orion 2
72
4.6.4.19 <RESTORE> command
The <RESTORE> command restores the startup configuration from the backup configuration,
which is written in the EEPROM.
As a result, values from the backup configuration are written into the startup configuration.
For example:
CO_FMM>RESTORE
Restored startup configuration from backup configuration.
Reset modem for all changes to take effect
CO_FMM>
The modem should be restarted in order the restored values become valid.
4.6.4.20 <DIFF N/R/S/B N/R/S/B > command
The <DIFF N/R/S/B N/R/S/B> command displays differences in configurations. The difference
between four configurations is displayed: Running, New, Startup, or Backup (see Section 2.3).
For example:
CO_FMM>DIFF R B
------------------------------------------------------------------------
Running configuration Backup configuration
------------------------------------------------------------------------
VLAN.VLANMASK.3
00 01 | 00 07
------------------------------------------------------------------------
CO_FMM>
The command displays the name of the difference parameter and data from two configurations.
In the above example one can see that the VLANMASK parameter of interface 3 (WAN2) of the
VLAN group in the running configuration differs from the backup configuration.
If there are no differences, the result is presented as follows:
CO_FMM>DIFF N R
------------------------------------------------------------------------
New configuration Running configuration
------------------------------------------------------------------------
--- No differences --- --- No differences ---
------------------------------------------------------------------------
CO_FMM>
4.6.4.21 <DUMP N/R/S/B > command
The <DUMP N/R/S/B> command displays the dump of the corresponding configuration:
Running, New, Startup or Backup. The text format used by the command can be also employed
for reading or for the configuration downloading in the modem with the help of the
LOAD
command (see below).
For example:
CO_FMM>DUMP R
------------------------------------------------------------------------
Dump of running configuration
------------------------------------------------------------------------
NET.MAC_ADDRESS
00 0F D9 00 10 03
M.DEVICE_ID
00 00 00 00 00 00 00 00 00 43 4F 4D 4D 4F 4E 00\
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00\
00
NET.MAC_SPEED