User Manual NTU Orion 2
55
Example:
• LINK 10 - Establish connection to subrack unit with slot number 10. Available only for
subrack units.
• LINK 00 - Establish monitor control node. Available only for subrack units.
• LINK FE - Establish monitor control node. Available only for common CLI RS232 Terminal
units.
Notes:
To refuse link connection just exit from controllable unit.
To refuse link connection urgently use CTRL+Z keystroke.
4.6.2.4 <LINKCLEAR> command
The < LINKCLEAR > command closes current virtual link connections.
4.6.3 Performance management menu
After typing “1” in the main menu and pressing<enter>, the following message is displayed:
Performance management activated
Enter <M> to return to MAIN, or <H> for HELP information
4.6.3.1 <H> command
Type
<H> and the monitor lists all available commands in the performance sub-menu:
CO_PM>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
TCPIP Show TCP/IP statistics
TCPIP C Show TCP/IP statistics continuously
MAC Show MAC Rx/Tx statistics
MAC C Show MAC Rx/Tx statistics continuously
G826 Display xDSL G.826 statistics
G826 C Display xDSL G.826 statistics continuously
G826 E1 Display E1 G.826 statistics
G826 E1 C Display E1 G.826 statistics continuously
ALLG826 N Display xDSL G.826 statistics for all link
RESETG826 Reset G.826 statistics
RESETALLG826 N Reset xDSL G.826 statistics for the whole link
LINKSTAT Display link status of all xDSL channels
ALARMLOG [N] Display the link alarm log
ALARMLOG C Clear the link alarm log
NETSTAT Show network interfaces statistics
RESETNETSTAT Reset network interfaces statistics
CONNECT [N:[1-13/R]] Establish connection to remote unit
LINK [NN] Establish local connection
LINKCLEAR Exit all local connections
M Return to Main Menu
H Show available commands
-------------------------------------------------------------------------------
CO_PM
To Next Page
Loading...
