FlexDSL ORION 2 - LINKSTAT> Command; ALARMLOG [N]> Command; ALARMLOG C> Command

User Manual NTU Orion 2
61
4.6.3.9 <LINKSTAT> command
The <LINKSTAT> command will show an steady quick status of the whole link.
--------------------------------------------------------------------------------
DSL 1
--------------------------------------------------------------------------------
CO link up
RR1 (N) link up
RR1 (C) link up
CP link up
--------------------------------------------------------------------------------
CO_PM>
4.6.3.10 <ALARMLOG [N]> command
The <ALARMLOG> command will show an steady quick status of the whole link. The number of
logs is limited to 1024 events.
The parameter N sets the number N of the DSL interface.
Example:
CP_MM>ALARMLOG 1
Alarm log for link at xDSL 1:
--------------------------------------------------------------------------------
Time ago | Unit | Event | Description
--------------------------------------------------------------------------------
04:45s | LOCAL | E1-2 | LOS-S ----- BER-S ----- -----
04:18s | RR 1 | N-SIDE | LOS ----- ----- ----- ----- LOOP2 -------
04:16s | CO | E1-1 | ----- ----- ----- ----- -----
--------------------------------------------------------------------------------
Output format is:
Time - the time since alarm was detected.
Unit - unit in link, that reported about alarm.
Event - interface of Unit, that detected alarm;
Description - list of alarms, that were detected on interface.
The list can contain several alarms for interface. In case, when
all alarms were cleared the list will only contain '----' items.
4.6.3.11 <ALARMLOG C> command
The <ALARMLOG C> command will clear all reported alarms.