User Manual NTU Orion 2
87
Note: It is also possible to set an empty password (in this case, the password is not requested
while opening the telnet session). This command sets the password only to access the device
over the telnet protocol. When managing the devices via the RS-232 interface, the password is
not requested.
4.6.5.20 <ID N> command
The <ID N> command is used to enter identification number of the device (N is the text
containing no more that 12 symbols). This ID will be displayed atop the main menu. If the
parameter is not written, the device ID will be empty.
4.6.5.21 <DEFAULT> command
The <DEFAULT N> command sets the default operation mode, where N is the mode number
(there are four default operation modes).
The DEFAULT 0 / 1 command sets the following mode: MASTER, PAM 32, BASERATE 89,
ANNEX B, transmission of all time slots of the E1 channel and Ethernet data overxDSL.
The DEFAULT 2 / 4 command sets the following mode: SLAVE, PAM AUTO, BASERATE
AUTO, ANNEX A/B,
4.6.5.22 <DEFAULT EVERYTHING> command
The
<DEFAULT EVERYTHING> command sets default operation modes for line parameters (see
the DEFAULT command), and for network parameters (see the
<NETDEFAULT> command).
The result of this command is similar to the result of two commands:
DEFAULT 0
4.6.5.23 <SERNUM> command
The <SERNUM> command shows the production serial number of the unit.
4.6.5.24 <GSCOMPAT> command
The <GSCOMPAT> command sets the Globespan (Conexant) compatibility mode on and off.
This feature will also limit the baserate to 36TS (PAM16).
4.6.5.25 <NMTHR> command
The <NMTHR> command allows to setup the desired Noise Margin alarm threshold in dB.
Syntax: NMTHR [value], where value is in the range from 0...25
NMTHR OFF disables the Noise Margin alarm threshold function
4.6.5.26 <LATHR> command
The <LATHR> command allows to setup the desired Line Attenuation alarm threshold in dB.
Syntax: LATHR [value], where value is in the range from 0...25
LATHR OFF disables the Line Attenuation alarm threshold function
To Next Page
Loading...
