User Manual NTU Orion 2
86
CO_CM>AISGEN ON
CO_CM>AISDET ON
4.6.5.16 <DSLTS list/NONE [N=1..4]> command
The
<DSLTS list/NONE [N=1..4]> command sets transmitted/received time slots of the given
E1 channel to be transmitted over the xDSL channel. Here, N is the number of the E1 interface.
The List consists of numbers of separate time slots and their ranges, separated by comma.
For example: 1,5,14-19.
The empty list is set by typing NONE. Spaces in the list are not allowed. Use the “minus” sign or
two dots “..” to set the range.
For modems with one xDSL channel, the command is as follows:
CO_CM>DSLTS 0-31
CO_CM>DSLTS 0-12,16
CO_CM>DSLTS 1..31
4.6.5.17 <WANTS [list] [N=1..4]> command (Ethernet via E1)
The <WANTS [list] [N=1..4]> command sets the list of time slots to be transmitted WAN data via
the E1 interface. Here N is the number of the E1 interface.
The List consists of numbers of separate time slots and their ranges, separated by comma.
For example: 1,5,14-19.
The empty list is set by typing NONE. Spaces in the list are not allowed. Use the “minus” sign or
two dots “..” to set the range.
For modems with one xDSL channel, the command is as follows:
CO_CM>WAN2TS 0-31
CO_CM>WAN2TS 12-18,19
CO_CM>WAN2TS 0-21,24
CO_CM>WAN2TS 1..21
Time slots used by the WAN2 data (the WAN2TS command) should differ from time slots of the
E1 channel (the DSLTS command) when they are transmitted over the xDSL interface.
4.6.5.18 <E1CLOCK [DSL/RX] [N]> command
The <E1CLOCK [DSL/RX] [N]> command sets the E1 output clock source for the WANTS
mode.
Examples:
E1CLOCK DSL The Rx clock of the DSL channel connected to this E1 interface
E1CLOCK RX E1 input clock.
4.6.5.19
<PASSWORD USER/ADMIN> command
The <PASSWORD USER/ADMIN> command is used to set user and administrator passwords.
CO_CM>PASSWORD USER
Enter password:
Confirm password:
Ok
Only the administrator can perform this command. The password length is no more than 11
symbols. The password can contain Latin letters and digits.
To Next Page
Loading...
