User Manual NTU Orion 2
78
4.6.5 Configuration Management menu
After typing “3” in the main menu and pressing enter, the following message will be displayed:
Configuration management activated
Enter <M> to return to MAIN, or <H> for HELP information
The content of the configuration management menu mainly depends on the operation mode of
the device. There are four possible modes of the device operation:
CO – all channels are in the Master mode, manual configuration.
CP – all channels are in the Slave mode, manual configuration.
CA – all channels are in the Slave mode, automatic configuration.
CX – a part of channels is in the Master mode, the rest channels are in the Slave mode, manual
configuration.
In the CA mode, configuration of E1 and WAN streams is received from the line (from the CO
device or regenerator), the configuration can be changed from the device in the CA mode. It is
impossible to configure the channel reservation, to arbitrarily assign E1 streams to DSL
channels and to arbitrarily set clock sources in the CA mode. Nevertheless, this mode satisfies
90% of users, because it does not require many efforts to configure the device.
In the CA mode, the configurations received from the line are displayed by using the <CONFIG>
command with the notation AUTO.
4.6.5.1 <H> command
Type
<H> and the monitor lists all available commands in the configuration management sub-
menu:
CO_CM>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
Type 'H [command]' to get additional help on [command]
AUTO [ON/OFF] Set CA mode
CONFIG Display local configuration
CONFIG [N/R/S/B] Display new/running/startup/backup configuration
MASTER [ON/OFF] [N] Select Nth xDSL channel master/slave
EXT [ON/OFF] [N] Turn Nth DSL channel Extended mode ON or OFF
BASERATE [N/AUTO] [M] Set Mth DSL channel baserate to Nx64k + 8k, N=[3..89]
PAM [4/8/16/32/64] [N] Set Nth xDSL channel line coding
PAYLOAD [list] [N] Set Nth xDSL channel payload
ANNEX [A,B,A/B] [N] Set Nth xDSL channel Annex A or Annex B or Annex A/B
SETCLOCK [list] [N] Set Nth xDSL channel clock source priorities
MULTIPAIR [2/OFF] Select or turn off multipair mode
RESERVE [list] Set the list of channels for the reserve group
G704 [ON/OFF] [N] Set Nth E1 framer G704 mode
G704 [ON/OFF] [N] Set Nth E1 framer G704 mode
AISDET [ON/OFF] [N] Set Nth E1 framer AIS detection mode
AISGEN [ON/OFF] [N] Set Nth E1 framer AIS generation mode
DSLTS [list] [N] Select Nth E1 channel timeslots, transmitted via DSL
WANTS [list] [N] Select Nth E1 channel timeslots for WAN payload
E1CLOCK [DSL/RX/EXT] [N] Set Nth E1 channel clock source priorities
PASSWORD [USER/ADMIN] Set user/administrator password
ID string Set device ID
DEFAULT [0-4] Set default configuration
DEFAULT EVERYTHING Set everything to default configuration
SERNUM Show serial number
To Next Page
Loading...
