FlexDSL ORION 2 - NETCONFIG [R;N;S;B]> Command

User Manual NTU Orion 2
89
4.6.5.31 <NETCONFIG [R/N/S/B]> command
Without parameters the
<NETCONFIG> command displays the running configuration of the
network subsystem and interfaces:
CO_09_NET>NETCONFIG
--------------------------------------------------------------------------------
Running Network Configuration
--------------------------------------------------------------------------------
VLANs & QoS
Interfaces : LAN WAN1 WAN2 INT
Mode : access trunk trunk access
QoS : 2 7
VLAN ID : 1 1
VLAN1 VID=1 : + +
VLAN2 VID=2 : + + Second
VLAN3 VID=3 : + + VLAN tag
VLAN4 VID=4 : + + OFF
VLAN5 VID=5 : + +
VLAN6 VID=6 : + +
VLAN7 VID=7 : + +
VLAN8 VID=8 : + +
OTHER VLANS : + +
QoS for HPQ : 3 3
Slicing for LPQ : 512 512
Ethernet:
Speed/Duplex : auto
System:
MAC address : 00:0f:d9:04:47:3f
IP address : 192.168.0.235
Subnet mask : 255.255.255.0
Default gateway : 192.168.0.254
SNMP:
Send traps to IP: 192.168.0.14
Community : public
SET command : Blocked
Alarm traps : Disabled
--------------------------------------------------------------------------------
CO_NET>
Definitions:
VLAN (VLANs & QoS) configurations
Interfaces Port identifier of the internal Ethernet switch
Mode Type of port (trunk or access)
QoS Priority for each of access ports
VLAN ID VLAN identifier for each of access ports
Second VLAN tag Configurations for the 2
nd
VLAN tag for the INT access port
VLAN1 VID=xx
VLAN2 VID=xx
VLAN3 VID=xx
VLAN4 VID=xx
VLAN5 VID=xx
VLAN6 VID=xx
VLAN7 VID=xx
VLAN8 VID=xx
Configurations and identifiers (xx=1..4094) for each of 8 VLANs which are
configured separately.
Pluses and minuses mark transmission/locking of VLAN for each of interfaces.
OTHER VLANS
Configurations for other VLANs, which are not configured separately.
Pluses and minuses mark transmission/locking for each of interfaces.