FlexDSL ORION 2 - Configuration of the Flexdsl Orion 2 Regenerator at the Regenerator Point

User Manual NTU Orion 2
110
7.2.3 Configuration of the FlexDSL Orion 2 regenerator at the Regenerator Point.
System configuration (Configuration Management menu):
<DEFAULT EVERYTHING> – enable default settings
Line interface configuration (Configuration Management menu):
<MASTER AUTO>
– enable automatic detection of the Master/Slave mode
<BASERATE AUTO> –
enable automatic detection of the line rate
Configuration of the internal Ethernet switch (Network Management submenu):
<SETIP 10.0.2.202>
–
set the IP address of the device (depends on the
configuration of the connected network)
<NETMASK 255.0.0.0>
–
set the subnet mask (this value is the same as in the
connected Ethernet network)
<GATEWAY 10.0.0.101>
– set the default gateway (this value is the same as in the
connected Ethernet network)
<SPECADRR 00:09:26:01:8А:03 2 2>
– VoIP has priority 2 in VLAN 2
<SPECADRR 00:09:26:01:8А:04 2 2>
– VoIP has priority 2 in VLAN 2
<SPECADRR 00:09:26:01:8А:05 3 2>
– management PC has priority 2 in VLAN 3
<SPECADRR 00:09:26:01:8А:06 3 2>
– management PC has priority 2 in VLAN 3
<INTERFACE LAN QOS 1>
– packet from the LAN port have priority 1
<INTERFACE WAN1 QOSTHRESHOLD
2>
– VLAN packets with QoS 2 or above have the highest priority
<INTERFACE INT VLAN 3>
– packets of the internal management port belong to VLAN 3
<INTERFACE INT QOS 2>
– packets from the LAN port have priority 0
<INTERFACE WAN1 ALLOW 1,2,3>
– transmit packets of VLAN 1,2,3 over the WAN1 port
Application of all configurations (Fault And Maintenance Management menu):
<APPLY ALL>
–
apply all configurations (written in the running configuration)
Confirmation of all configurations (Fault And Maintenance Management menu):
<CONFIRM>
–
confirm all configurations (written in the startup
configuration)