FlexDSL ORION 2 - STATUS ETH> Command

User Manual NTU Orion 2
65
Power backoff N Output signal power reduction[dB]
Far end power
backoff
N Far end signal power reduction [dB] (in the current version invalid
values are displayed)
Loop attn N Attenuation in the loop [dB]
NMR N Maximum possible increase in the noise margin for which the BER
is expected to be no less that 10
-7
[dB]
Bitrate N Data transmission rate in the xDSL line [kbit/s]
SRU N Number of regenerators in the system
Active sync.
source
External
E1-1
E1-2
Internal
Active sync source
External sync
Е1-1 network interface
Е1-2 network interface
Internal sync source
Temperature N Unit temperature [С°] (only for SubRack devices)
Power mode P0
P1
P2
P3
P4
P5
CPU clock frequency is 50MHz.
CPU clock frequency is 50MHz smart start
CPU clock frequency is 25MHz smart start
CPU clock frequency is 10MHz smart start
CPU clock frequency is 5.5MHz smart start
CPU clock frequency is 5.5MHz smart start
For the STATUS L explanation please see the CONFIG command explanations.
4.6.4.4 <STATUS ETH> command
The <STATUS> command displays parameters of the Ethernet port (ETH1 – ETH4), namely the
rate and the operation mode:
CO_09_FMM>STATUS ETH
Ethernet port speed/duplex: 100 FULL