User Manual NTU Orion 2
73
5A
SNMP.TRAPIP.0
00 00 00 00
SNMP.TRAPIP.1
00 00 00 00
SNMP.COMMUNITY
43 4F 4D 4D 4F 4E 00 20 60 00 00 13 00 02 B2 3C\
00 18 65 44 00 05 5E 2C FF FF FF FF 00 17 59 F8\
00
M.ALARM_CUTOFF
02
NET.IP
C0 A8 5A 14
NET.NETMASK
FF FF FF 00
NET.GATEWAY
C0 A8 5A 64
NET.PPPREMIP
C0 A8 5A 5A
PE1.G704.0
01
SE1.G704.1
01
PE1.CRC4DET.0
00
SE1.CRC4DET.1
00
...
------------------------------------------------------------------------
CO_FMM>
The results of the command show the coded configuration of the device and can be copied from
the terminal window into the notepad as well as saved on any data carrier. This txt file can be
downloaded into a similar device with the help of the LOAD command via the XModem or 1K
XModem protocols.
4.6.4.22 <LOAD> command
The <LOAD> command downloads the configuration file obtained with the help of the DUMP
command into a device via the XModem or 1K XModem protocols.
For Windows 95 or above, this procedure can be performed with the help of the HyperTerminal
program. By typing LOAD, the following text will be displayed in the terminal window:
CO_FMM>LOAD
Now upload configuration via XModem or 1K XModem
C
Select "Send File” in the Transfer menu. Select the protocol XModem or 1K XModem in the
window which appears. Select the downloading configuration file and click the Send button.
If downloading is successful, a message will appear to reset the modem:
Configuration was loaded successfully.
For all configuration options to apply, type RESET to reset modem.
CO_FMM>
If the configuration file contained errors, a message with the number of the line in which the
error was detected will be displayed. The configuration of the device in this case will not
change.
To Next Page
Loading...
