User Manual NTU Orion 2
95
4.6.5.42 <SNMPSET ON/OFF> command
The <SNMPSET ON> command enables processing SNMP SET requests, which allows one to
configure and manage the device, however, this command makes the device sensitive to
attacks over SNMP in unprotected PC networks.
The <SNMPSET OFF> command disables processing SNMP SET requests, which protects the
device from network attacks, but does not allows one to configure and manage it.
Use this command to process SNMP SET requests only in protected networks. If the network is
not protected, use this command during configuration and administration only.
4.6.5.43
<ALARMTRAP ON/OFF> command
The <ALARMTRAP ON/OFF> command allows to enable /disable specific alarm traps. When
ALARMTRAPS is disabled, no Specific alarm TRAPS like NM- or LA alarm traps will be sent.
4.6.5.44 <NETDEFAULT> command
The <NETDEFAULT> command sets the following configuration:
CO_09_NET>NETCONFIG
--------------------------------------------------------------------------------
Running Network Configuration
--------------------------------------------------------------------------------
VLANs & QoS
Interfaces : LAN WAN1 WAN2 INT
Mode : access trunk trunk access
QoS : 2 7
VLAN ID : 1 1
VLAN1 VID=1 : + +
VLAN2 VID=2 : + + Second
VLAN3 VID=3 : + + VLAN tag
VLAN4 VID=4 : + + OFF
VLAN5 VID=5 : + +
VLAN6 VID=6 : + +
VLAN7 VID=7 : + +
VLAN8 VID=8 : + +
OTHER VLANS : + +
QoS for HPQ : 3 3
Slicing for LPQ : 512 512
Ethernet:
Speed/Duplex : auto
System:
MAC address : <factory address>
IP address : <not changed>
Subnet mask : <not changed>
Default gateway : <not changed>
SNMP:
Send traps to IP:
Community : COMMON
SET command : Blocked
Alarm traps : Disabled
--------------------------------------------------------------------------------
CO_09_NET>
The modem MAC address takes the factory value. The default IP address, sub-network masks
and gateway are not changed.
4.6.5.45 <M> command
The <M> command in the NET submenu displays the Configuration Management menu.
To Next Page
Loading...
