FlexDSL ORION 2 - AUTO [ON;OFF]> Command; CONFIG;N;R;S;B> Command

User Manual NTU Orion 2
79
APPLY [ALL/GROUP] Apply changes to running configuration
GSCOMPAT [ON/OFF] Set GS compatibility mode on and off
NMTHR [N/OFF]] Set the Noise Margin alarm threshold
LATHR [N/OFF] Set the Line Attenuation alarm threshold
MODE [N] Sets the number of DSL channels to N
CONNECT [N:[1-13/R]] Establish connection to remote unit
LINK [NN] Establish local connection
LINKCLEAR Exit all local connections
LICENSE [LICENSE_KEY] Display activation info/Enter license key
NET Network configuration menu
M Return to Main Menu
H Show available commands
-------------------------------------------------------------------------------
CO_CM>
4.6.5.2 <AUTO [ON/OFF]> command
The <AUTO ON> command sets the CA mode for the device, i.e., all channels are in the Slave
mode, automatic configuration.
In this case, all DSL interfaces pass to the Slave mode. The majority of configurations is
received from the line. The MULTIPAIR mode remains unchanged.
The <AUTO OFF> command sets the manual configuration mode for the device. If this
command is sent from a mode, which differs from the CA mode, it has no effect. If the command
is sent from the CA mode, the current configurations of the line are written in the configurastion.
4.6.5.3 <CONFIG /N/R/S/B> command
The <CONFIG> command displays the configuration of the device.
Options:
N - Display New line configuration
R - Display Running line configuration
S - Display Startup line configuration
B - Display Backup line configuration
For devices in the CO, CP, CX modes:
CO_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL DSL1 DSL2
Mode : Master(HTU-C) Master(HTU-C)
Extended rates: OFF OFF
Line coding : PAM16 PAM16
Baserate : 60 60
Annex : B B
Payload : E1-1,WAN E1-2,WAN
Clock source : E1-1,Int E1-2,Int
Reserve : --- ---
GS compatible : OFF
NM threshold : OFF
LA threshold : OFF
E1 E1-1 E1-2
G.704 framing : ON ON
CRC4 : ON ON
AIS Detection : ON ON
AIS Generation: ON ON
E1 clock : DSL DSL