FlexDSL ORION 2 - Page 80

User Manual NTU Orion 2
80
TS into DSL : 0-31 0-31
TS into WAN : NONE NONE
--------------------------------------------------------------------------------
CO_CM>
For devices in the CA mode:
CA_CM>CONFIG
--------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL DSL1 DSL2
Mode : ---- All slave, AUTO ON ----
Extended rates: OFF OFF
Line coding : AUTO AUTO
Baserate : AUTO AUTO
Annex : A/B A/B
Payload : E1-1,WAN E1-2,WAN
Clock source : E1-1,Int E1-2,Int
GS compatible : OFF
NM threshold : OFF
LA threshold : OFF
E1 AUTO E1-1 E1-2
G.704 framing : ON ON
CRC4 : ON ON
TS into DSL : 0-31 0-31
E1 MANUAL
AIS Detection : ON ON
AIS Generation: ON ON
E1 clock : DSL DSL
TS into WAN : NONE NONE
--------------------------------------------------------------------------------
CA_CM>
Definitions:
Group of xDSL parameters
Mode
Operation mode:
Master
Slave
Multipair
All slave, configured by master
All slave, MULTIPAIR xx, configured by master
Extended rates: Extended DSL feature ON / OFF
Line coding Type of the line encoding ([PAM64], PAM32, PAM16)
Baserate Data transmission rate over the line interface. Auto – adaptation mode
Annex Transmission mode (ANNEX A, ANNEX B, ANNEX AB)
Payload
Data transmitted over the interface: the list of E1 streams transmitted over this interface
or/and WAN
Clock source List of priority clock sources
Reserve The reservation group to which the DSL channel belongs.
GS compatible Enables the Globespan (Conexant) compatibility.
NMTHR Set / disable the NoiseMargin threshold alarm.
LATHR Set / disable the LineAttenuation threshold alarm