User Manual NTU Orion 2
81
Group of E1 parameters
G.704 framing Framing mode
CRC4 CRC4 mode
AIS Detection AIS detection mode
AIS Generation AIS generation mode
E1 clock Clock source
TS into DSL List of time slots of E1 transmitted/received overt DSL
TS for WAN List of time slots of E1 used for WAN data список WAN (Ethernet over E1)
Note: New configuration is displayed automatically every time changes are made to the
configuration.
The main operation modes of a device are:
Independent channels (CO, СP, CX, CA)
Independent channels with reservation (CO, СP, CX)
Multipair mode (CO, СP, CX, CA)
Two-pair mode with reservation (available only in the four-channel version) (CO, СP, CX)
The CONFIG table for the mode with independent channels is presented above. The table lists
all possible configurations of independent channels.
Table representing the mode of “independent channels with reservation”. In this configuration,
channels 1, 2 and 3, 4 are combined for reservation (CO, CP, CX).
The CONFIG always displays the running line configuration. If a new configuration differs from
the running one, the CONFIG command lists the running configuration and displays a warning:
CP_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL DSL1
Mode : Slave(HTU-R)
..Extended rates: OFF
Line coding : PAM32
Baserate : 89
Annex : A
Payload : E1-1,WAN
Clock source : E1-1
E1 E1-1
G.704 framing : ON
CRC4 : ON
TS0 Generation: OFF
AIS Detection : ON
AIS Generation: ON
E1 clock : DSL
TS into DSL : 0-31
TS into WAN : NONE
--------------------------------------------------------------------------------
Warning: New line configuration differs from running line configuration!
To view new/running line configuration, type 'CONFIG N'/'CONFIG R'.
To apply changes in configuration, type 'APPLY LINE' or 'APPLY ALL'.
Do not forget to 'CONFIRM' a good working configuration.
CP_CM>
To Next Page
Loading...
