EasyManua.ls Logo

FlexDSL ORION 2 - SOFTUPDATE> Command; SOFTCONFIRM> Command; SOFTINFO> Command

FlexDSL ORION 2
115 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual NTU Orion 2
70
For example: if it is necessary to deactivate alarm statuses of the group Е1-1 and DSL, enter
the ACO command twice: first, with the parameter Е1-1, and second, with the parameter DSL.
CP_FMM>ACO E1-1 ON
E1-1, ETHERNET
CP_FMM>ACO DSL ON
E1-1, xDSL, ETHERNET
CP_FMM>
4.6.4.13 <SOFTUPDATE> command
The
<SOFTUPDATE> command downloads the new software into the modem by using the
XMODEM or 1K XMODEM protocols. The SOFTUPDATE command downloads only the
second version of the software into the flash memory. During the new software downloading the
analysis of the % symbols is not performed.
CP_FMM>SOFTUPDATE
Flash manufacturer: Spansion
Flash device: S29AL016D(02)
Start address: 0x1000000
Flash size: 2048 KB
Now upload program via XModem or 1K XModem
CСС
After the new software is successfully downloaded, a message is displayed to restart the
modem.
If the downloading failed, a message is displayed and the modem returns to the usual operation
mode. (The operator can try again to download the software.) If the downloading was
interrupted, the software is most likely damaged. The restart will result in this case in the
downloading of the first version of the software.
4.6.4.14 <SOFTCONFIRM> command
The
<SOFTCONFIRM> command confirms the new version of the software. After the new
software is downloaded, a counter of the running software starts is switched on. If this software
is not confirmed with the help of the
<SOFTCONFIRM> command after the restart, it will not be
valid after the next restart.
CO_FMM>SOFTCONFIRM
Software confirmed
CO_FMM>SOFTCONFIRM
Software already confirmed
CO_FMM>
4.6.4.15 <SOFTINFO> command
The <SOFTINFO> command displays information about copies of the software, which are
stored in the device.
The device can contain two copies (different versions are possible) of the software. One of them
is started after switching on, while the other is a backup software.
CP_FMM>SOFTINFO
1: ver.: 1.5.0, date: 30.11.2007, length: 435k, CRC OK, fixed
2: * ver.: 1.5.9, date: 17.11.2008, length: 457k, CRC OK, confirmed
CP_FMM>
The asterisk shows the running downloaded version.

Table of Contents

Related product manuals