EasyManua.ls Logo

FlexDSL ORION 2 - H> Command; LICENSE [LICENSE_KEY]> Command; MODE N> Command; NET> Command

FlexDSL ORION 2
115 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual NTU Orion 2
88
4.6.5.27 <LICENSE [LICENSE_KEY]> command
With the <LICENSE [LICENSE_KEY]> command its possible to display or to enter the license
key.
4.6.5.28 <MODE N> command
The <MODE N> command sets number of xDSL interfaces system will operate with.
For example:
the MODE 1 in a V53 unit (2 channel unit) disables channel 2 on the V53 unit.
To setup this configuration parameter you should perform the following command sequence:
1. Apply and confirm all configuration changes
2. Issue MODE [N] command
3. RESET
After the reset unit will work with specified number of xDSL channels.
4.6.5.29 <NET> command
The <NET> command allows one to enter the submenu for configuration of the network
subsystem and NET interfaces. Type <M> to return to the main menu.
4.6.5.30 <H> command
Type <H> to list all available commands:
CO_NET>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
NETCONFIG Show network configuration
NETCONFIG [N/R/S/B] Show new/running/startup/backup network configuration
INTERFACE NAME CMD PARAM Set network interfaces parameters
ETHSD [MODE] Set ethernet speed
SLICING [SIZE/OFF] Set LPQ packing size
SETIP x.x.x.x Set modem IP address
GATEWAY x.x.x.x Set gateway IP address
NETMASK x.x.x.x Set netmask
VID [1-8] ID Assign VID to the VLAN specified
V2T {[VIQ] [QoS]}|OFF Set/remove second VLAN tag for INT interface
TRAPIP [ADD/DEL] x.x.x.x Set/delete IP address for SNMP trap messages
COMMUNITY Set SNMP community name
SNMPSET [ON/OFF] Enable/disable SNMP SET commands.
ALARMTRAPS [ON/OFF] Enable/disable the specific alarm traps.
NETDEFAULT Set default network configuration
APPLY [ALL/GROUP] Apply changes to running configuration
CONNECT [N:[1-13/R]] Establish connection to remote unit
LINK [NN] Establish local connection
LINKCLEAR Exit all local connections
M Return to Configuration Management Menu
H Show available commands
-------------------------------------------------------------------------------
CO_NET>

Table of Contents

Related product manuals