FlexDSL ORION 2 - SHOW > Command; RES > Command; SET [E11-E12] [INT;EXT] > Command; TS [TX;RX] [0-31] > Command

User Manual NTU Orion 2
77
4.6.4.31 <SHOW > command
This command shows the actual status of the BERT.
CO_BERT>SHOW
Testing E1-1, External output
--------------------------------------------------------------------------------
BERT status G.826
--------------------------------------------------------------------------------
Sync : Sync loss Errors : 0
Alarms : ALL 0s Errored seconds : 0
Bitrate TX : 0 Severely errored seconds : 0
Bitrate RX : 64000 Background block errors : 0
Bit errors : 0 ESR [%] : 0.00
Pattern time : 0 SESR[%] : 0.00
Error ratio : 0 BBER [%] : 0.00
No errors for : 0 Available time : 0
Total test time : 120 Unavailable time : 120
--------------------------------------------------------------------------------
CO_BERT>
4.6.4.32 <RES > command
This command resets the BERT statistics.
4.6.4.33 <SET [E11-E12] [INT/EXT] > command
This command set’s the desired Interface to the selected source.
4.6.4.34 <TS [TX/RX] [0-31] > command
This command set’s the desired Slot for the BERT.
Examples:
TS 0-31 will select timeslots 0-31 for TX and RX
TS TX 1-31 will select TX timeslots separately
TS RX 1-31 will select RX timeslots separately
4.6.4.35 <PATD [2En/bitstring] > command
With this command it’s possible to setup the BERT pattern.
Parameters: 2E7, 2E9, 2E11, 2E15 or bitstring
4.6.4.36 <CONF > command
This command shows the current BERT configuration.