User Manual NTU Orion 2
53
4.5 Command syntax
The following rules are used to describe commands:
• parameters in angular brackets < > are obligatory;
• parameters in direct brackets[ ] are not obligatory;
• the symbol ( / ) between parameters requires to enter one of the listed parameters;
• in real commands brackets and the vertical line are not entered, they are used for
description;
• after the command is typed, press <enter>.
4.6 Commands
4.6.1 Main Menu
The main menu is presented as shown below:
MODEL FG-PAM-SA2N-2E1B/Eth, V51
HW 1.1
SW 1.5.9
DATE 17-11-2008
ID
RUNS 0d 01:13:07
ALARM URGENT
STATUS LINK DOWN
MODEL_DESC Standalone Dual xDSL/Dual E1/Ethernet 120 Ohm
IP 192.168.0.235
------------- Main Menu -----------------
1. Performance management (PM)
2. Fault and maintenance management (FMM)
3. Configuration management (CM)
5. Exit
-----------------------------------------
Select [1..5]
CO_MM>
To select the desired sub-menu, type the appropriate number from “1” to “5” and press<enter>.
To Next Page
Loading...
