FlexDSL ORION 2 - Page 91

User Manual NTU Orion 2
91
The NETCONFIG command always displays the running configuration. If the new configuration
differs from the running one, the NETCONFIG command displays the running configuration and
a warning:
CO_09_NET>NETCONFIG
--------------------------------------------------------------------------------
Running Network Configuration
--------------------------------------------------------------------------------
VLANs & QoS
Interfaces : LAN WAN1 WAN2 INT
Mode : access trunk trunk access
QoS : 2 7
VLAN ID : 1 1
. . .
MAC address : 00:0f:d9:00:a0:89
IP address : 10.0.8.100
Subnet mask : 255.0.0.0
Default gateway : 10.0.0.101
SNMP:
Send traps to IP:
Community : public
SET command : Blocked
Alarm traps : Disabled
--------------------------------------------------------------------------------
CO_09_NET>
Warning: New line configuration differs from running line configuration!
To view new/running line configuration, type 'CONFIG N'/'CONFIG R'.
To apply changes in configuration, type 'APPLY LINE' or 'APPLY ALL'.
Do not forget to 'CONFIRM' a good working configuration.
CO_09_CM>
The <NETCONFIG [R/N/S/B]> command displays one of four configurations: Running, New,
Startup, or Backup, depending on the parameter.
For example, the command NETCONFIG B will display the backup configuration:
CO_09_NET>NETCONFIG B
--------------------------------------------------------------------------------
Running Network Configuration
--------------------------------------------------------------------------------
VLANs & QoS
Interfaces : LAN WAN1 WAN2 Int
Mode : access trunk trunk access
QoS : 2 7
VLAN ID : 1 1
. . .
System:
MAC address : 00:0f:d9:00:a0:89
IP address : 10.0.8.58
Subnet mask : 255.0.0.0
Default gateway : 10.0.0.101
SNMP:
Send traps to IP:
Community : COMMON
SET command : Blocked
Alarm traps : Disabled
--------------------------------------------------------------------------------
Warning: New network configuration differs from running network configuration!
To view new network configuration, type 'NETCONFIG N'
To view running network configuration, type 'NETCONFIG R'
To apply changes in configuration, type 'APPLY NET' or 'APPLY ALL'.
Do not forget to 'CONFIRM' a good working configuration.
CO_09_NET>