Flintec EM100-C - Commands Overview

EM100-C User Manual
0084292
Page 23 of 81
4. Commands Overview
Command Factory Default Parameter Range Description
A’n’ Zero. 0…2dec.
Allocation Source for a Set-Point
(Gross, Net or Average).
AD
Zero.
0…255dec.
Set Device Address (0=perm active).
AG
20000 10000.
±33000dec. (mV/V)
Absolute Gain Calibration.
AZ
Zero.
±33000dec. (mV/V)
Absolute Zero-Point Calibration.
BR 9600. 9600…460800dec. Baud Rate.
CE No Default. 0…65535dec.
Open Calibration Sequence. Read
TAC Counter.
CG 20000. 1…99999dec.
Set Calibration Gain (Span) at Load
> Zero.
CI
-99999.
-99999…0dec.
Minimum Output Value.
CL
No Default.
N/A
Close Device Communication.
CM1 99999. 1…99999dec. Set Maximum Output Value (n=1).
CM2
Zero.
0…99999dec.
Set Maximum Output Value (n=2).
CM3
Zero.
0…99999dec.
Set Maximum Output Value (n=3).
CS
No Default.
N/A
Save Calibration Data.
CTR Zero. 0…1dec. CAN Termination Resistor Selector.
CZ
No Default.
N/A
Set Calibration Zero Point (no-load).
DP
3.
0…6dec.
Set Decimal Point Position.
DS 1.
1, 2, 5, 10, 20, 50,
100, 200, 500dec.
Set Display Step Size.
DT 50. 0…65535dec.
Calculation Time for Short-Time
Average (ms).
DX
Zero.
0…1dec.
Set Duplex Mode.
FD No Default. N/A Restore Factory Default Settings.
FFV
0101.
N/A
Identify Firmware Version.
FL
3.
0…8dec.
Filter Cut-Off Frequency.
FM
Zero.
0…1dec.
Filter Mode.
FPN No Default. N/A Get Device ID.
GA
No Default.
N/A
Get Triggered Average Value.
GG
No Default.
N/A
Get Gross Value.
GH
No Default.
N/A
Get Hold Weight Value.
GL No Default. N/A
Get Data String (Average, Gross,
Status).
GM No Default. N/A Get Peak Value.
GMV
No Default.
N/A.
Get mV/V Value.