Flintec EM100-C - Page 25

EM100-C User Manual
0084292
Page 25 of 81
SN
No Default.
N/A
Send Net Value Continuously.
SP
Zero.
0…999999dec.
Preset Tare Value.
SR
No Default.
N/A
Software Reset.
SS No Default. N/A
Save Set-point Parameter Values to
Non-Volatile Memory.
ST
No Default.
N/A
Set Tare Value.
STR Zero. 0…1dec.
RS-485 Termination Resistor
Selector.
SW No Default. N/A
Send Data String (Net, Gross,
Status) Continuously.
SX No Default. N/A
Send ADC Sample Value
Continuously.
SZ
No Default.
N/A
System Zero Value.
TD
20.
0…255dec.
Transmit Delay (ms).
TE
Zero.
0…1dec.
Trigger Edge.
TH
None.
N/A
Trigger Hold Value.
TI
Zero.
0…65535dec.
Averaging Time for Automatic Taring
TL
999999.
0…999999dec.
Trigger Level Value.
TM
Zero.
0…3dec.
Tare Mode Value.
TMV
No Default.
N/A.
Apply Tare to mV/V.
TN
Zero.
0…1dec.
Set/Clear Non-Volatile Tare.
TR
No Default.
N/A
Software Trigger.
TS
Zero. 0…65535dec. Stop Value for Re-Trigger.
TT
65535ms.
0…65535dec.
Average Time for Re-Trigger.
TW
Zero. 0…65535dec. Window for Automatic Taring.
UR
Zero.
0…7dec.
Output Averaging Update Rate.
WP No Default. N/A
Save Setup Data to Non-Volatile
Memory.
WT
Zero.
0…65535secs.
Warm-Up Time Value.
ZI
Zero.
0…999999dec.
Initial Zero Range Value.
ZN
Zero.
0…1dec.
Set/Clear Non-Volatile Zero.
ZR
Zero.
0…999999dec.
Manually Set Zero Range.
ZT
Zero.
0…255dec.
Enable/Disable Zero Tracking.