Flintec EM100-C - Page 3

EM100-C User Manual
0084292
Page 3 of 81
5.2.5. DS Set Display Step Size .......................................................................................... 29
5.2.6. DP Set Decimal Point Position ................................................................................... 30
5.2.7. CZ Set Calibration Zero Point .................................................................................... 30
5.2.8. CG Set Calibration Gain (Span) ................................................................................. 30
5.2.9. ZT Enable/Disable Zero-Tracking .............................................................................. 31
5.2.10. FD Reset to Factory Default Settings ..................................................................... 31
5.2.11. IZ Correction of System Zero ................................................................................. 31
5.2.12. ZR Zero Range ...................................................................................................... 32
5.2.13. ZI Initial Zero Range ............................................................................................... 32
5.2.14. TM Tare Mode ....................................................................................................... 32
5.2.15. TN Set/Clear Non-Volatile Tare .............................................................................. 33
5.2.16. ZN Set/Clear Non-Volatile Zero .............................................................................. 33
5.2.17. AZ Absolute Zero Point Calibration (eCal) .............................................................. 33
5.2.18. AG Absolute Gain Calibration (eCal) ...................................................................... 34
5.2.19. WT Warm-Up Time ................................................................................................ 34
5.3. Motion Detection Commands – NR, NT ......................................................................... 35
5.3.1. NR Set No-Motion Range .......................................................................................... 35
5.3.2. NT Set No-Motion Time ............................................................................................. 35
5.4. Filter Setting Commands – FM, FL, UR ......................................................................... 36
5.4.1. FM Filter Mode .......................................................................................................... 36
5.4.2. FL Filter setting .......................................................................................................... 36
5.4.3. UR Update Rate & Averaging .................................................................................... 38
5.5. Taring & Zeroing Commands – SZ, RZ, ST, RT, SP, TMV, RMV ................................... 39
5.5.1. SZ Set System Zero .................................................................................................. 39
5.5.2. RZ Reset Zero ........................................................................................................... 39
5.5.3. ST Set Tare ............................................................................................................... 40
5.5.4. RT Reset Tare ........................................................................................................... 40
5.5.5. SP Set Preset Tare .................................................................................................... 40
5.5.6. TMV Set Tare (mV/V) ................................................................................................ 40
5.5.7. RMV Reset Tare (mV/V) ............................................................................................ 41
5.6. Output Commands – GG, GN, GT, GS, GMV, GW, GA, GL, OF, GH, TH, GM, RM, GO,
GV, HW ....................................................................................................................................... 42
5.6.1. GG Get Gross Value .................................................................................................. 42
5.6.2. GN Get Net Value ...................................................................................................... 42
5.6.3. GT Get Tare Value .................................................................................................... 42
5.6.4. GS Get ADC Sample Value ....................................................................................... 42
5.6.5. GMV Get mV/V Value ................................................................................................ 42