Flintec EM100-C - Page 4

EM100-C User Manual
0084292
Page 4 of 81
5.6.6. GW Get Data String (Net, Gross & Status) ................................................................ 43
5.6.7. GA Get Triggered Average Value .............................................................................. 44
5.6.8. GL Get Data String (Average, Gross & Status) .......................................................... 44
5.6.9. OF Output Format of Data String ............................................................................... 44
5.6.10. GH Get Hold Value ................................................................................................ 45
5.6.11. TH Trigger Hold Value ........................................................................................... 45
5.6.12. GM Get Peak Value ............................................................................................... 45
5.6.13. RM Reset Peak Value ............................................................................................ 45
5.6.14. GO Get Peak-to-Peak Value .................................................................................. 45
5.6.15. GV Get Valley Value .............................................................................................. 46
5.6.16. HW Hold Weight .................................................................................................... 46
5.7. Auto–Transmit Commands – SG, SN, SX, SMV, SA, SL, SW ....................................... 47
5.7.1. SG Send Gross Value Continuously .......................................................................... 47
5.7.2. SN Send Net Value Continuously .............................................................................. 47
5.7.3. SX Send ADC Sample Value Continuously ............................................................... 47
5.7.4. SMV Send mV/V Sample Value Continuously ........................................................... 47
5.7.5. SA Send Triggered Average Value Continuously ....................................................... 47
5.7.6. SL Send Data String Continuously (Average, Gross & Status) .................................. 48
5.7.7. SW Send Data String Continuously (Net, Gross & Status) ......................................... 48
5.8. Commands for External I/O Control – IN, OM, IO ......................................................... 49
5.8.1. IN Read Status of Logic Inputs .................................................................................. 49
5.8.2. OM Control of Logic Outputs by Host Application ...................................................... 49
5.8.3. IO Read/Modify Status of Logic Outputs .................................................................... 49
5.9. Set-Point Output Commands – S’n’, H’n’, A’n’ ............................................................. 51
5.9.1. S‘n’ Set-Point Value ................................................................................................... 51
5.9.2. H’n’ Hysteresis & Switching Action for Set-Point ........................................................ 51
5.9.3. A’n’ Source Allocation for Set-Point ........................................................................... 52
5.10. Communication Setup Commands – AD, NA, NS, BR, DX, CL, OP, TD, CTR, STR,
SBR 53
5.10.1. AD Device Address – Serial Channel ..................................................................... 53
5.10.2. NA Network Address – CANopen ........................................................................... 53
5.10.3. NS Network Settings – CANopen ........................................................................... 53
5.10.4. BR Baud-Rate – Serial Channel ............................................................................. 54
5.10.5. DX Full-Duplex – Serial Channel ............................................................................ 54
5.10.6. CL Close Device Address ‘n’ .................................................................................. 54
5.10.7. OP Open Device .................................................................................................... 54
5.10.8. TD Transmission Delay .......................................................................................... 55