5500A
Operator Manual
4-20
Note
At voltage outputs of 100 volts and above (nominal), you may notice a
slight high-pitched sound. This is normal.
5. Press a multiplier key, if necessary. For example, press c.
6. Output in volts Press V.
Output in dBm Press bV.
7. The Control Display now shows the amplitude of your entry. For example,
2.44949 V (below).
2.44949 V
8. Press the numeric keys and decimal point key to enter the desired frequency output
(maximum five numeric keys). Press a multiplier key, if necessary. For example,
press the kilo multiplier key K. Then press the H key. For example, 1.1234
kHz (below).
2.44949 V
1.1234 kHz
9. Press E. The calibrator clears your entry from the Control Display and copies
it into the Output Display (below is typical).
STBY
2.44949 V
1123.4 Hz
10. Press O to activate the calibrator output.
Several softkey labels appear on the Control Display in the ac voltage function,
depending on which waveform is selected: DUTY, OFFSET and WAVE.
OFFSET
WAVE
sine
tri
square
truncs
DUTY
50.00
square
See
specifications.
+0.00000 V
1.00 to
99.00%
To Next Page
Loading...
