Remote Commands
Command Summary by Function
6
6-7
Status Commands
ERR? Returns the first error code contained in the 5500A error queue, then removes that
error code from the queue.
EXPLAIN? Explains an error code. This command returns a string that explains the error code
furnished as the parameter.
FAULT? Returns the first error code contained in the 5500A error queue, then removes that
error from the queue.
ISCE Loads two bytes into both the Instrument Status 1 to 0 Change Enable register and
the Instrument Status 0 to 1 Change Enable register.
ISCE? Returns the OR of the contents of the Instrument Status 1 to 0 Change Enable
register and the Instrument Status 0 to 1 Change Enable register.
ISCE0 Loads two bytes into the Instrument Status 1 to 0 Change Enable register.
ISCE0? Returns the contents of the Instrument Status 1 to 0 Change Enable register.
ISCE1 Loads two bytes into the Instrument Status 0 to 1 Change Enable register.
ISCE1? Returns the contents of the Instrument Status 0 to 1 Change Enable register.
ISCR? Returns the OR of the contents of the Instrument Status 1 to 0 Change Register and
the Instrument Status 0 to 1 Change Register and clears both registers.
ISCR0? Returns and clears the contents of the Instrument Status 1 to 1 Change Register.
ISCR1? Returns and clears the contents of the Instrument Status 0 to 0 Change Register.
ISR? Returns the contents of the Instrument Status Register.
Thermocouple (TC) Measurement Commands
TC_MEAS Changes the operating mode to thermocouple MEASUREMENT.
TC_OFFSET Sets a temperature offset for the thermocouple measurement mode.
TC_OFFSET? Returns the temperature offset when in the thermocouple measurement mode.
TC_OTCD? Returns whether or not the open thermocouple detection circuit is set.
TC_OTCD Activates or deactivates the open thermocouple detection circuit in thermocouple
measurement mode.
VAL? Returns the last thermocouple (TC) measurement value.
VVAL? Return the last value of the Thermocouple measurement in volts.
RS-232 UUT Port Commands
UUT_FLUSH Flush the UUT receive buffer.
UUT_RECV? Return data from the UUT serial port.
UUT_SEND Sends a string to the UUT serial port.
UUT_SET Sets the UUT serial port settings and saves them in nonvolatile memory.
UUT_SET? Returns the UUT serial port settings contained in nonvolatile memory.
To Next Page
Loading...
