Fluke 5500A - Page 69

Features
Softkey Menu Trees
3
3-9
25
I
The +/- (Polarity) key changes the polarity of the output for dc voltage or dc current functions.
Press the +/- key then ENTER to toggle the output polarity.
26
The TRIG OUT (Trigger Output) BNC connector is used to trigger the oscilloscope during
oscilloscope calibration. This is active only when the ScopeCal option is installed.
27
The SCOPE (Oscilloscope) connector is used for outputs during oscilloscope calibration. This is
active only when the ScopeCal option is installed.
28
The TC (Thermocouple) connector is used for thermocouple simulation during temperature meter
calibration, and thermocouple measurements. You must use the correct thermocouple wire and
plug when using this connector. For example, if simulating a K thermocouple, use K-type
thermocouple wire and K-type plug for making connections.
29
The AUX (Auxiliary Output) jacks are used for ac and dc current outputs, the second voltage
output in dual voltage modes, and ohms sense for 2-wire and 4-wire compensated resistance and
capacitance measurements, and RTD simulation.
30
The NORMAL (Normal Output) jacks are used for ac and dc voltage, ohms and capacitance
sourcing, and Resistance Temperature Detector (RTD) simulation.