5700A/5720A Series II
Operators Manual
5-16
Table 5-1. Command Summary by Function (continued)
Calibration, Testing, and Diagnostics Commands for the Calibrator (continued)
DIAGFLT Sets the calibrator’s response to faults in remote diagnostics
DIAGFLT? Returns the calibrator’s response to faults in remote diagnostics
OHMSREF? Returned calculated resistance reference (Main software revision H and after)
STOP_PR Stops printing a report
*TST? Performs a series of self tests and returns the results
Serial Only Remote Commands
LOCAL Puts the calibrator into the local state
LOCKOUT Puts the calibrator into the local lockout state
REMOTE Puts the calibrator into remote state
Status Commands
*ESE Loads the Event Status Enable register
*ESE? Reads the Event Status Enable register
*ESR? Reads and clears the Event Status Register
ETIME? Elapsed time query. Returns the cumulative number of minutes powered on.
EXPLAIN Decodes a fault code by returning a brief description
FAULT? Returns the most recent fault code from the fault queue
*IDN? Returns calibrator identification information
ISCE Loads the Instrument Status Change Enable register
ISCE? Reads the Instrument Status Change Enable register
ISCR? Reads and clears the Instrument Status Change Register
ISR? Reads and clears the Instrument Status Register
ONTIME? Returns the number of minutes since power-up this session
*OPT? Returns a list of installed modules and attached amplifiers
*SRE Loads the Service Request Enable register
*SRE? Reads the Service Request Enable register
STATE? Returns the long-term state of the calibrator
*STB? Returns the status byte
UNCERT? Returns the calculated absolute uncertainty of the output
To Next Page
Loading...
