Fluke 5700A Series II User Manual

5700A/5720A Series II
Operators Manual
A-2
221 5725 +400V Supply Current Too High
222 Output Tripped To Standby
223 5725 -400V Supply Current Too High
224 Output Tripped To Standby
225 5725 Fan Not Working
226 5725 CLAMPS Fault
227 Output Tripped To Standby
228 5725 Software TRAP
229 5725 Cable Was Off
230 5725 RESET (power-up or watchdog timer)
231 5725 Guard-Crossing Timeout
232 5725 Illegal/Unexecutable Command
233 5725 Non-Maskable Interrupt Occurred
234 5725 HVCLEAR Circuit Activated
235 Output Tripped To Standby
400-Level Faults: Calibration Constant Subsystem
400 Bad Cal Constant ID
500-Level Faults: Configuration Finder Subsystem
500 Bad Mode To CNFmodeRanges
501 Configuration Table Overflow
502 Bad Amplifier Type Selection
503 Bad Flat Constant Type Selection
504 Bad Flat Constant Type In Table
505 5725 Guard Crossing Wouldn't Start
600-Level Faults: Dot Matrix Display Driver Subsystem
600 Bad Row Selector
601 Bad Column Argument
602 Bad Character
800-Level Faults: Executive Subsystem
800 Wideband Module Needed
801 Amplifier Not Selected Or Connected
802 Amplifier Must Remain On For This Output
803 Over Limits Of Locked Range
804 Under Limits Of Locked Range

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V