Fluke 5700A Series II User Manual

Appendices
Fault Codes
A
A-3
806 Invalid Date
807 Invalid Time
808 DC dBm Not Allowed
809 Ext Ref Value Out Of Range
810 Bad Edit Digit Movement
811 Not Wideband Units
812 Cannot Set Frequency With Ohms
813 Bad Units
814 Wrong Polarity For Limit
815 Outside Entry Limits
816 Magnitude Too Large For Calibrator
817 Magnitude Too Small For Calibrator
818 Frequency Too Large For Calibrator
819 Frequency Too Small For Calibrator
820 Calibrator Cannot Source That Value
821 V Limit Outside Calibrator Ability
822 I Limit Outside Calibrator Ability
823 Cannot Adjust Frequency To <<= 0 Hz
824 Offset Not Allowed Now
825 Scale Not Allowed Now
826 Ohms Reading Set Too High
827 Ohms Reading Set Too Low
828 Cannot Use External Sense Now
829 Cannot Use Phase Shift Now
830 Cannot Use Phase Lock Now
831 Cannot Use 2-ire Comp Now
832 Could not Do Default Wideband Output
833 Bad Selector For Set/Get Item
834 Cannot Boost This Output Mode
835 Cannot Use Ext Sense On Selected Range
836 Cannot Use 2 Wire Comp On Selected Range
837 Cannot Lock This Range
838 Cannot Set Clock, Rear Switch In NORMAL
839 Cannot Fmt EEPROM, Rear Switch In NORMAL

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V