Fluke 5700A Series II User Manual

5700A/5720A Series II
Operators Manual
A-4
840 Illegal Output Post For Current
841 No 5725 Available For Selected Output
842 Not A Valid Wideband Flatness Point
843 Wideband Flatness Cal Is Not Active
844 Report String Too Long
845 Cannot Store, Rear Switch In NORMAL
846 Range Calibration Is Not Active
847 Magnitude Too High For Range Cal
848 Magnitude Too Low For Range Cal
849 Invalid Calibrator Setup Block
850 Cannot Format, 5725 Switch In NORMAL
851 Cannot Store, 5725 Switch In NORMAL
852 Calibration Steps Out Of Order
853 Cannot Use External Guard Now
854 Cannot Use Ext Guard On Selected Range
855 Cannot Set String, Rear Switch in NORMAL
856 Present Output Exceeds Selected Limit
857 Bad Selector For Reference Calibration
858 Cannot Change Range Now
859 Hardware Not Installed For This Range
860 Cannot Use Amplifier For This Output
861 5725 Cannot Ext Sense At That Frequency
900-Level Faults: Keyboard Driver Subsystem
900 Keyboard Output Queue Full
1000-Level Faults: 5725 Communication Receive Subsystem
1000 Could not ACK Packet From 5725
1001 Illegal 5725 Receive Task State
1002 Bad Receive Packet Number From 5725
1003 Bad Control Byte From 5725
1100-Level Faults: 5725 Communication Transmit Subsystem
1100 Multiple Timeouts Sending To 5725
1101 5725 Request Reset Loop
1102 Unexpected NSA From 5725
1103 Bad Packet Number In ACK From 5725

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V